However, if you break out the modules and want to connect them with Grove cables, please kindly check the Breakout Guide. Note: If you installed the portable Arduino IDE from our USB Drive, you can find all the module demos in the Files -> Sketch Book, as well as all the module libraries, are pre-installed with Arduino IDE!Īll modules are pre-wired on a single circuit board, so no cables and soldering are needed. After the compilation is successful, press the upload button(→).Ħ.Navigate to Tools -> Serial Monitor, or click the Serial Monitor in the upper right corner(Magnifier Symbol), you can see the program running results: First, press the Verify button(✓) to compile. For Mac OS users, it should be /dev/cu.SLAB_USBtoUART.Ĥ.Create a new Arduino file and name it Hello.ino, then copy the following code into it:ĥ.In the upper left corner of the Arduino IDE, there are two buttons, Verify and Upload. Select Arduino Uno as Board.ģ.Click Tools -> Port to select the correct Port (the Serial Port showed in Device Manager in the previous step). At this point, the driver should be reinstalled.Ģ.Click on Tools -> Board-> Arduino AVR Boards-> Arduino Uno to select the correct Development Board Model. If the driver is not installed, or if the driver is installed incorrectly (not matching the chip model), it will appear as an "unknown device" in the device manager.For Mac OS users: You can navigate to on the top left corner, and choose About this Mac -> System Report.For Windows users: You can see it in My Computer -> Properties -> Hardware -> Device Management.After the driver installation is completed, connect Arduino to the USB port of PC with a USB cable.Note: USB chips are usually printed on the back of the development board. The USB driver depends on the type of USB chip you're using on your Arduino. Download and Install Arduino IDE for your desired operating system here.Īrduino connects to the PC via a USB cable.Arduino IDE is an integrated development environment for Arduino, which is used for single-chip microcomputer software programming, downloading, testing and so on.How to Get Started With Arduino Install the Arduino IDE Scroll -> Rotating Rotary Potentiometerīuzzer and LED module are used for key prompt.The Grove Beginner Kit has a plug and plays unboxing demo, where you first plug in the power to the board, you get the chance to experience all the sensors in one go! Use the button and rotary potentiometer to experience each sensor demo! Hands-on implementation of Open Source Hardware projects.Communication principles and methods for sensors.Basics of Open Source Hardware Systems.Shake the modules up and down and it should come out quite easily! Part List Modules Use a knife or a sharp object to cut at the stamp holes that connect the sensors together If you prefer to use the modules in elsewhere then you can simply follow the procedures to break the modules out! Please be careful not to cut your hands when using a knife This means you don't need to use Grove cables to connect if not broken out.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |